Part 2 of 2. But you already knew that, didn't you? Again, please report any problems with the instructions!
About this creation
Here's where the rubber band comes in. It doesn't matter what kind it is, as long as it's small enough to run through the recessed edges on the grey 1x1 stud plates...
Like this! If you don't have a rubber band that's small enough, just twist one back on itself, like in the photo.
Remember! When you put this section in, the rubber band must be in place!
Also, I suggest you twist the rubber band into a figure-eight, to keep it from rubbing against the sides of the slide.
The completed slide and barrel!
THE COMPLETED COLT .25 AUTOMATIC!!
And there you are, ready to hold up your local gas station.
JUST KIDDING! On a more serious note, DO NOT go waving the model around in public, unless you want a free ride in a police car. Please remember where you got the designs if you post it, and be careful!