Cabover Kenworth Car Transporter. Triangulate This in 'Real Vehicle'.
About this creation
Well, here she is. Front 3/4. You can see the full load of brand new cars.
Slightly more frontal.
Right hand side. You can really see how big it is.
Rear 3/4. All the cars, loaded up! The rear ramp does not raise, nor does the top. I tried to engineer it, but it made an extra 2 studs width, and nothing fitted on.
Rear shot. You can see the ‘Do Not Overtake Turing Vehicle’ red and yellow signs, as well as the Australia flag. The 1x2 plate is custom printed.
Left hand side. You can see the sleekness of the cab.
Front 3/4. The white with blue stripe is more a wagon/van style. The blue stripe is from the police car.
Empty truck, ready for loading.
Truck cab. Based on a modified Kenworth K108.
Truck cab. Notice the steps to reach the cab.
The load of cars. Only one is the original set, four are modified versions, and two are from chassis I already had. My favourite is the red. Which one is yours?
I'm going to judge this as if the cars were not part of the build (as you make no mention of them in your initial description). BUT you need to clearly state that next time you try something similar! That being said, the truck by itself really isn't all too impressive. The cab is fine, but the trailer lacks definition and detail. 2 points.
Unfortunately Lee, you are correct. I'm holding that car in my hand as we speak. >.< Does this mean he will get DQ'd for using sets in his entry, or will he make it because he only stated the truck was the entry?