Since so many people loved this thing, and I got a request to post instructions I've broken down the steps to build one of these bad boys.
About this creation
Ok, first off: this MOC is not for purists. There is a small amount of cutting to be done. You need to cut a four-stud long rod exactley (or as close as you can) in half. I was able to do this with just a pocket knife, so it shouldn't be too hard.
Alright, now to the contruction. You're going to stick each half of the rod into two 2X2 round plates. Makes sure the studs face eachother and are aligned so each one faces an empty space on the other plate.
This part's easy: the base of the motorcycle.
Aftyer that, you add three "claw pieces" and one 1X1 round stud.
Now you add what will become the front of the motorcycle.
Do the same thing for the back. The droid arms should should press against the base.
Next, add the rear wheel cover and a 1X2 plate to the front half of the base.
Next, add 2 "cheese slopes" and a 1X2 single hinge part.
On the hinge, add the front wheel cover.
On top of that, add another cheese slope and an upward claw piece.
Next, add the handlebars and two binocular pieces on the side of the motorcycle.
And now... you add the wheels!
Last thing to do is press the wheel covers down. Both wheel supports should be pressed against the base still.
The empty claw on the left side can be used for weapons storage.
So there you have it! Hope you all enjoy this beast of a motorcycle :P
Keep an eye out for more episodes of No Refuge! You can visit the official No Refuge page here: http://mocpages.com/group.php/9682
Very good. I shall make one as soon as I come back from holiday and i think i shall avoid cutting the pipe in half by adding a brick im thinking of but don't know the name. It's the one where it's like a straight pipe but then there is another pipe coming out of it from the bottem. If i remember what its called I'll tell you.
Awesome, love the bike, might make it. I actually found out how to make most of it by just looking at it. But for the wheels u dont really need to cut a bar, just use one of those T piece things similar to the one you used in your gun but different