This is my custom clone speeder. It seats one pilot and can hold a blaster rifle. It hovers over the ground and has two cannons on the side. Included are some lengthy but easy to follow instructions.
The first step is quite simple as you can tell.
The second step is just adding a 1 by 2 to the original foundation.
The third step is very easy. When done set this aside for later.
Make one of these and set it aside.
The fifth step is the opposite of the fourth step. Set this aside as well.
The sixth step show's the fourth and fifth step next to each other.
then attach them to a 4 by 4 with the third step.
The next step you see the seventh step with the second step.
Next combine them.
Build this simple piece and......
set it on the eighth step.
Add this piece on the main foundation.
And your almost done.
Take these pieces and combine them to make.
This.
Add this bar.
And attach it to this
Now we will put them together.
And it should look like this.
Add these bars.
And your cannons are made.
Next take two small discs.
And attach them to the bottom.
The finished product.
I hope the instructions were easy to follow, thanks for stopping by.