This is something I'm currently in the design phase of.
About this creation
I'm currently designing this in MLCAD. This is a side shot view, planning to throw a couple more plates on the bottom to give it a little more detail.
Head on shot. Any body know have any good suggestions for warp nacelle designs? Going to be interesting to figure out how to affix them to the hull.
Top shot. I'm not too sure how to widen the back here, the reference pic leads me to believe the cargo area bulges slightly here, and i'm trying to figure out how to make it flow.
I think the engine intakes on the bottom are going to give me headaches.
3/4 view, this thing will have some nice swooshability if I can pull it off. I'm looking for any helpful suggestions to get this thing off the ground. Sensing a major bricklink purchase in my future.
Three shots of the progress I've made so far.
I think I've figure out how to widen that back section to my liking. Well off to bed now.
And moc pages ate my formatting, screw it I'm going to bed.