SVMS-01O Over Flag (W.I.P.) (Gundam 00): A LEGO® creation by Thomas Z. : MOCpages.com

SVMS-01O Over Flag (W.I.P.) (Gundam 00)

Rate it

Add a comment

Zoom in

The head of the Over Flag that I'm working on at the moment. I might change the design in the future, but I'd like to hear some feedback on this one, I'm not sure if it's good accurate enough.

About this creation

A little size comparsion

Comments

Add a comment

I made it

Thomas Z.

September 13, 2011

Quoting Larry Steele that really is quite awesome but the faceplate is chrome gold & rounded if i remember correctly; so can u use an astronaut's chrome helmet shield just wedged in? Put the face shield on a helmet with a minifig head inside and attach to a 1x2 jumper plate?

I'm still experimenting with the head design but so far this is the closest one to the original. Also, thanks for the idea, but I think there isn't much room left in the head for a minifig head because of the camera, and besides the face isn't really that round, at least at some pictures the roundness is barely noticable and it's more of an orange color then gold. If you don't belive me than look at these :P http://www.mahq.net/mecha/gundam/00/svms-01o.htm or http://imageshack.us/f/366/flagkf8.jpg/

I like it

Larry Steele

September 13, 2011

that really is quite awesome but the faceplate is chrome gold & rounded if i remember correctly; so can u use an astronaut's chrome helmet shield just wedged in? Put the face shield on a helmet with a minifig head inside and attach to a 1x2 jumper plate?

I made it

Thomas Z.

July 23, 2011

Quoting evangelionfanx xd Thats an amazing Head!!! If you think its a bit off i should slap you XD Its perfect. You even added the camera behind the MASK!!1!!!!1 How long did it take you to design I give it a 12 out of 10 so far.

Thanks! Well, it took me about 2 days to finalize the head. I had about 2 versions before this one, but they looked either too small or too big so the third one was made from the previous two. Right now I'm having problems doing the transforming mechanism, so I don't know when this will be finished. Until then I'll upload some other creations that I haven't done so far.

I like it

evangelionfanx xd

July 22, 2011

Thats an amazing Head!!! If you think its a bit off i should slap you XD Its perfect. You even added the camera behind the MASK!!1!!!!1 How long did it take you to design I give it a 12 out of 10 so far.

I made it

Thomas Z.

July 18, 2011

Quoting Marcus Jackson NICE! I can't wait to see a good flag. None I've seen are at the same scale you and mithryl build. I've found these on brickshelf, they're not at your scale, but still might be helpful.

Thanks for the links! Right now I only have the head completed. I aim to make the MOC transformable with all the gimmicks, like the landing gear, blade stored in the arm, and so on..