these are instructions to my minigun. hope they make sense.
About this creation
Heres a view of all the parts you need.
take the 1 by 1 dot with two holes and stick the small grey dot on the bottom of it
then stick the technic lookin axel where the grey dot is on
then add the the two or three technic sliding things on. ( you can make many different designs)
then put the one dot plate with the bar on it on one of the sides of the 1 by 1 square
then put the cone lookin thing on the bar.
then put the 1 by 2 plate with the bars on one of the sides
then flip it over and put the small wedge plate on the dot. then you want to rotate it so the big end is at a 45 degree angle( this is where it spits all the brass out on a real minigun)
heres a view of the stand. its really easy to make. then to attach it you just put the 1 dot on the side of the 1 by 2 bar plate. (i hope this all makes sense) thanks for looking. please rate and comment.