1970's Ford Mustang Mach I: A LEGO® creation by George Staples : MOCpages.com

1970's Ford Mustang Mach I

Rate it

Add a comment

Zoom in

About this creation

Super secret project! Shhh!! Ok so its not a secret now. I wanted to build a six wide version of this car, but while building, I found out the tires I have are too small for a six wide. The front looked a little weird. So I ended up building this one. It's a 8 wide? 10 wide? Actually its like a 10-11 wide. I used a different building Technic to make this, so it doesn't really line up with a 10 wide brick.

This technic I used to make the car was pretty easy to do. If you noticed, the two pictures above, one has a lower floor, than the other. That's because I initially made the car without an interior. Then I thought it looked a little drab, so I built a interior in 30min. (I had to hurry before the sun went down.) And I think it looks much better.

No interior (Before)

Interior (After)

Rear

Front

Alternative title photo.

So maybe I got a little carried away with the photo editing. I used GIMP and found some brushes at blendfu.com If you want your photo edited like this, send me an email with your photo. Or send me an email if you want help with GIMP. Other photos I've edited here. Thanks for looking!

Comments

Add a comment

I like it

Chris Melby

February 24, 2012

George, I really dig how you used the plate on end look, I am becoming more and more of a fan of these new building techniques, the axle mounts are trick as well. Nice 5/5 Chris

I made it

George Staples

February 18, 2012

Hey thanks every for your comments every one!

I like it

Gabor Horvath

February 18, 2012

Cool! The rear is absolutely a Mustang, but the other parts are very good, too. I like the techniques you used. The best are the exhaust pipes and the suspension. Maybe it would be bettet, if it was 3 studs wide, but this isn't important. Great job!