MOCpages : Share your LEGO® creations
LEGO models my own creation MOCpages toys shop shotgun style m16/ak47Weapons
Welcome to the world's greatest LEGO fan community!
Explore cool creations, share your own, and have lots of fun together.  ~  It's all free!
shotgun style m16/ak47
a shotgun style ak47/m16 that fires 1x4 pieces
About this creation
the is the cocking handle pulled back, with the bolt retainer on.


















this is my gun. it is a cross between a shotgun, an m16, and an ak47.

the gun holds 10 bullets in each clip (i made 2), is single shot, and fires about 6 and 1/2 metres from the end of the barrel, at my shoulder height (about 140cm), with the gun level.

the mechanism works in a basic way.
the bullets are inserted into the clip, stud to stud, bottom to bottom. the clip is attached into the reciever in the gun.
when you pull the cocking lever back (see pic 2), an axle stopper piece is pulled bak from out the barrel, past the camber, and up into a little rachet setup. the axle stopper is also attached to 2 rubber bands that run back down the barrel to where they are attached to part of the fore-sight.
at the same time, the bolt pushes a bullet out of the clip (if it is inserted), then up into the chamber, where it is held in place by a piece on a spring that pushes it up and squishes it against the roof of the chamber.

when you pull the trigger, the rachet setup i talked about earlier is released, allowing the axle stopper to slide towards the chamber at huge speeds. when it hits the bullet, it has to take it with it, as the barrel is not tall enough for it to pass. the bullet and the "hammer" then rush along the barrel, with the bullet leaving very, very fast at the other end.



Comments

 I like it 
  June 17, 2011
please give me the LDD for this ur awesome :)
 I like it 
  September 17, 2010
Great job ( as usual) but reneme it AS VAL, special-purpose silenced automatic rifle.
 I like it 
  December 27, 2009
its exelelent but i dont like the looks
 I like it 
  February 5, 2009
Beautiful gun, just a few questions: 1) would you post instructions for the clip and/or gun? 2)What kind of rubber bands do you use for the mags?
 I like it 
  November 10, 2008
No offends, but you are shooting precious bricks away!!! BTW, it looks more like a Tommy gun. Anyway, very nice gun!
 I like it 
  August 19, 2008
amazing work. id love to see it in action :D
 I like it 
  July 11, 2008
omg. check my page.
 
By Jack Streat
Add to my favorite builders

18
people like this. See who.

15,781 visitors
7 comments
Added July 11, 2008
 


LEGO models my own creation MOCpages toys shop shotgun style m16/ak47Weapons


You Your home page | LEGO creations | Favorite builders
Activity Activity | Comments | Creations
Explore Explore | Recent | Groups
MOCpages is an unofficial, fan-created website. LEGO® and the brick configuration are property of The LEGO Group, which does not sponsor, own, or endorse this site.
©2002-2014 Sean Kenney Design Inc | Privacy policy | Terms of use