Ferrari F40 (Revisited) . So, last night I completely rebuilt my F40, and I'm sure you'll all agree that this is a vast improvement on the first one :D
On a side note, seeing as the only other 5 wide F40 on this site is my Mk.I, I think I can safely say that this is the best Ferrari F40 of this scale on MOCpages ;) . Built: 2011
Be sure to check out Nils O's fantastic 4-wide version of my F40 here!
Ok, This is my Mk.II F40. The only thing that's similar to the original is the front and the roof. But I've still made changes to those elements. All-in-all, it's a brand new car.
Also, I couldn't decide if I wanted black or grey wheels, so I put the colours on different sides of the car for the photos.
Thanks goes to MortalSwordsman for his suggestion to swap the solid and transparent cheese pieces on the front. I swapped the clear for a smoked though, I think that ties in with the black stripe better.
One of my favourite things about the new car is the side intakes. I made them a lot smaller, and also a lot smoother.
Overall, the car is two studs shorter, which makes the car look a bit stumpier which I like n_n Also, these dimensions are a lot more accurate to the reference blueprint I was using. (If enough people question this, I'll post the blueprint)
The front. Well, it's pretty much exactly the same. Thats not a bad thing though, I liked the front of the original anyway.
I used SNOT techniques for the rear, which worked out well because that ment that the spoiler sits just a little bit higher than the roof.
Once again, I love those intakes! :D
The rear is the area that is most changed the most from the original. I got rid of the black stripe and replaced it with a more detailed bumper and a proper tail light strip using smoked elements to match the driving lights.
One of my favourite angles of the car. You can see the curve of the intakes and the angle of the custom exhaust.
I like the spoiler a lot more too. It sits slightly higher than the original and is also half the depth, so it is a lot more accurate.
Looking pretty in red. I also made the bonnet longer, which is evident in this photo.
A high shot of the rear, reveiling the louvers on the rear window. Oh, and of course those intakes! ;)
A hight shot of the other side.
A final shot, looking very Fezza-like. I like this version infinately more than the original. :D
Before you go, I have three questions for you;
1. Which wheel colour did you like most?
2. Do you think I should make a yellow version?
3. Most importantly, do you like this more than the original?
I would greatly appreciate it if you could spend 1 minute to answer them. Thankyou! As always, I hope you like it, thanks for viewing etc, etc :) Now, if you'll excuse me, I have to go and make horribly immature race car noises while playing with my F40 ;)
UPDATE: 1st of August 2011
Due to an overall vote of 'Yes', I have made a yellow version, and I like the yellow more than the red (colour wise). The two cars are the same except for 3 elements; the bonnet, the rear diffusor and the colour of the tail lights. I couldn't find my 4th 2x1 trans-black plate for the tail lights, so I had to use trans red instead. I used the red on the red F40, as it kind of looked weird on the yellow one.
The bonnet is slightly flatter because I didn't have enough 3x1 arches, so I had to use 4x1 arches instead. I also don't have any yellow 1x1 clips that I used for the rear diffusor. I'm not even sure if LEGO makes them O_O So I tried different colours such as grey, black and even white. I decided that blue-grey was the best colour as I could pass it off as exposed carbon fibre.